Doing tests with the Samsung Galaxy S6 vs. the iPhone, we found that the delta in the RSSI between the devices seeing the same beacon at various distances did not stay consistent: For tagging movable items with an iBeacon, the RadBeacon Tag works best. Its battery powered, and has a hole in it through which something like a cable tie or wire can be passed to attach the tag. Radius Networks, founded in 2011, offers a variety of proximity beacon. ![]() The RSSI offset between the iPhone and the Galaxy S6 Edge + does not stay consistent with changes in distance. Its smallest beacon, RadBeacon Dot, offers an adjustable range of five to 50. For this technique to work, we need the delta RSSI in dB to be consistent for a device even as the distance increases.The RadBeacon™ app is the configuration utility for RadBeacon proximity beacons from Radius Networks that support Apple's iBeacon™ proximity services as well as other emerging proximity services. The RadBeacon app from Radius Networks requires an iOS iPhone, iPad or iPod touch running iOS 7.1 or higher and equipped with Bluetooth 4.0 capabilities. With the RadBeacon app you can scan for nearby configurable Radius Networks beacons. Once discovered, you can display each beacon's operating settings and make modifications to those settings. Each beacon discovered is displayed with the following summary details Scan for nearby configurable RadBeacons by swiping down on the RadBeacons table. Select any RadBeacon in the table to view it's detailed settings. Press the Action Menu button and select Apply. Submit a valid PIN to update the settings for this beacon. Press the Action Menu button and select Calibrate.Ĭalibrate the measured power value of the beacon settings to ensure optimal proximity events and ranging. Update the measured power value with the results of your calibration activity and update your settings. The Dot proximity beacon is lightweight, small in size, and easy to deploy. Press the Action Menu button and select Range. It’s the perfect beacon for conferences, trade shows, and other events where power may not be readily available and ultimate flexibility in placement is most important. Validate the accuracy of your beacon settings by quickly verifying the ranging behavior of your device in proximity to your configured beacon. Press the Action Menu button and select Update PIN. Submit a new and existing PIN to update the PIN for your beacon. Press the Action Menu button and select Reset. Reset the device to the original factory settings. Submit a valid PIN to reset the settings for your beacon to factory defaults. Press the Action Menu button and select Lock. Submit a valid PIN to prevent connections from remote Bluetooth 4.0 devices to the beacon configuration service. Radius Networks offers a wide range of hardware, software and proximity. The Lock feature is a security precaution to limit the possibility of third party manipulation of your beacons once they have been installed and configured. RadBeacon Dot is in the lightweight plastic enclosure, based on coincell battery. In order to re-enter configurable mode for a RadBeacon USB, remove and restore power to the device. In order to re-enter configurable mode for a RadBeacon Tag, remove the front cover and press the configuration push button switch near the coin cell battery. In order to re-enter configurable mode for a RadBeacon X2, remove the front cover and switch the beacon power switch to OFF and back to ON.Ī beacon set in configurable mode will be configurable for up to 30 minutes or until you lock the device again. Press the Action Menu button and select DFU. ![]() Reboot the beacon into Direct Firmware Update mode.Ĭontact Radius Networks support for information on the procedure for firmware update or replacement. In order to re-enter normal operational model, simply remove and replace power to the device.
0 Comments
Leave a Reply. |